Subaru Legacy: Security ID plate
1) Key number plate
2) Security ID plate
The security ID is stamped on the security ID plate attached to the key set. Write down the security ID and keep it in another safe place, not in the vehicle. This number is needed to make a replacement key if you lose your key or lock it inside the vehicle.
To make replacement keys, the key number is also needed. Refer to “Key replacement” F2-4.
The security ID is also needed for replacement or repair of the engine control unit, integrated unit, combination meter (all models) and security control unit (Canada-spec. models).
Immobilizer
The immobilizer system is designed to prevent an unauthorized person from starting the engine. Only keys registered with your vehicle’s immobilizer system can be used to operate your vehicle. Ev ...Security indicator light
The security indicator light deters potential thieves by indicating that the vehicle is equipped with an immobilizer system. It begins flashing approximately 60 seconds after the ignition switch ...See also:
Telephone commands
Phone
Your phone system allows you to createan additional phonebook. The storedentries can be dialled by voice control.
Phone numbers stored by using voicecontrol are stored on the vehicle systemand ...
Uniform tire quality grading
DOT (Department of Transportation) Quality
Grades: All passenger car tires must conform to
federal safety requirements in addition to these
grades.
Quality grades can be found where applicable on
...
Delayed Locking
When locking the doors with the
power lock switch and a door is
open, the doors will lock
five seconds after the last door is
closed. You will hear three chimes
to signal that the delayed lo ...