Subaru Legacy: Security indicator light
The security indicator light deters potential thieves by indicating that the vehicle is equipped with an immobilizer system. It begins flashing approximately 60 seconds after the ignition switch is turned from the “ON” position to the “Acc” or “LOCK” position or immediately after the key is pulled out.
If the security indicator light does not flash, the immobilizer system may be malfunctioning. If this occurs, contact your SUBARU dealer as soon as possible. In case an unauthorized key is used (e.g. an imitation key), the security indicator light illuminates.
NOTE
Even if the security indicator light flashes irregularly or its fuse blows (the light does not flash if its fuse is blown), the immobilizer system will function normally.
Security ID plate
1) Key number plate
2) Security ID plate
The security ID is stamped on the security ID plate attached to the key set.
Write down the security ID and keep it in another safe place, not in the veh ...
Key replacement
Your key number plate and security ID plate will be required if you ever need
a replacement key made. Any new key must be registered for use with your vehicle’s
immobilizer system before it can ...
See also:
When the tire pressure warning light comes on (if equipped)
Check the tire inflation pressure and adjust to the appropriate level.
Pushing the tire pressure warning reset switch will not turn off the tire
pressure warning light. ...
Owner Information
Owner publications are written
specifically for owners and intended
to provide basic operational
information about the vehicle. The
Owner Manual includes the
Maintenance Schedule for all
m ...
Center console box (rear)
The center console box has a two-layer structure consisting of an upper compartment
and a lower compartment.
Upper compartment
1) Upper compartment lock release Pull up the upper compartment l ...
