Subaru Legacy: Select lever/gear position indicator - Warning and indicator lights - Instruments and controls - Subaru Legacy Owners ManualSubaru Legacy: Select lever/gear position indicator

1) Upshift/downshift indicator (AT and CVT models)

1) Upshift/downshift indicator (AT and CVT models)

This indicator shows the position of the shift lever (MT models) or select lever (AT and CVT models).

Immobilizer system
This light blinks approximately 60 seconds after the ignition switch is turned from “ON” position to the “Acc” or “LOCK” position or immediately after the key is pulled out. Refer to ...

Upshift/downshift indicator (AT and CVT models)
When the manual mode is selected, the gear position indicator (which shows the current gear selection) and the upshift/ downshift indicator light up. Refer to “Automatic transmission/Continuousl ...

See also:

Trunk lid (Legacy) – if the trunk lid cannot be opened
The trunk lid can also be opened using the key. To open the trunk lid, insert the key into the key cylinder and turn it clockwise. ...

ENGINE OVERHEATED — STOP ENGINE
This message displays and a continuous chime sounds if the engine cooling system reaches unsafe temperatures for operation. Stop and turn off the vehicle as soon as it is safe to do so to avo ...

Seat Heaters
EX-L and all V6 models Both front seats are equipped with seat heaters. Because of the sensors for the side airbag cutoff system, there is no heater in the passenger’s seat-back. The igni ...