Honda Accord: Seat Heaters
EX-L and all V6 models
Both front seats are equipped with seat heaters. Because of the sensors for the side airbag cutoff system, there is no heater in the passenger’s seat-back. The ignition switch must be in the ON (II) position to use the heaters.
Push the right side of the switch, HI, to rapidly heat up the seat. After the seat reaches a comfortable temperature, select LO by pushing the left side of the switch. This will keep the seat warm.
In the HI setting, the heater turns off when the seat gets warm, and turns back on after the seat’s temperature drops.
In the LO setting, the heater runs continuously. It does not cycle with temperature changes.
Follow these precautions whenever you use the seat heaters:
Use the HI setting only to heat the seats quickly, because it draws large amounts of current from the battery.
If the engine is left idling for an extended period, do not use the seat heaters even on the LO setting. It can weaken the battery, causing hard starting.
Folding Rear Seat
The back of the rear seat folds down,
giving you direct access to the trunk.
The seat-back is released from inside
the trunk.
When storing cargo, you can move
the rear center shoulder belt o ...
Driving Position Memory System
U.S. V6 models, and Canadian EX-L and
V6 models with navigation system
Your vehicle has a memory feature
for the driver’s seat position.
Seat, except for power lumbar,
position can be stored ...
See also:
Rear seat air conditioner (if so equipped)
The rear seat passengers can adjust the climate control system using the climate
controls in the rear armrest panel.
1. AUTO button.
2. button.
3. switch.
For information on canceling the rear ...
Sensor
The solar sensor, located on top of
the instrument panel near the
windshield, monitors the solar heat.
The climate control system uses the
sensor information to adjust the
temperature, fan sp ...
Center console controls
Center console controls for menu navigation
1 - Press MY CAR to access the My Car menus.
2 - Press OK/MENU to select a highlighted selection or to store a certain function
in the system's me ...
