Chrysler 200: Mist Feature
Push down on the wiper control lever to activate a single wipe to clear the windshield of road mist or spray from a passing vehicle. As long as the lever is held down, the wipers will continue to operate.
NOTE:
The mist feature does not activate the washer
pump; therefore, no washer fluid will be sprayed on the
windshield. The wash function must be used in order to
spray the windshield with washer fluid.
Mist Control
Windshield Washers
To use the washer, pull the windshield wiper/washer
control lever toward you and hold it for as long as
washer spray is desired.
If you activate the washer while the wiper control is in
the del ...
Headlights With Wipers Feature (Available With Automatic Headlights Only)
When this feature is active, the headlights will turn on
approximately 10 seconds after the wipers are turned on
if the multifunction lever (on the left side of the steering
column) is placed in ...
See also:
Fuses and Circuit Breakers
The wiring circuits in the vehicle are protected from short circuits by a combination of fuses and circuit breakers. This greatly reduces the chance of damage caused by electrical problems.
To check ...
Alarm
The system sounds the alarm and flashes the lights when forced
entry is detected.
■ Triggering of the alarm
The alarm is triggered in the following situations when the alarm
is set:
χ ...
Media center 130 (RES) — AM/FM stereo radio with CD player (MP3 AUX JACK)
NOTE: The radio sales code is located on the lower rightside of the radio faceplate.
Media Center 130
(RES)
Operating Instructions — Radio Mode
NOTE: The ignition switch must be in the ON or ...
