Honda Accord: Installing a Child Seat with a Tether
A child seat with a tether can be installed in any seating position in the back seat, using one of the anchorage points shown above.
Since a tether can provide additional security to the lap/shoulder belt installation, we recommend using a tether whenever one is required or available.
Using an Anchor
1. After properly securing the child seat, lift the head restraint, then route the tether strap over the seat-back and through the head restraint legs.
2. Lift the cover, then attach the tether strap hook to the anchor, making sure the strap is not twisted.
3. Tighten the strap according to the seat maker’s instructions.
Installing a Child Seat with a Lap/Shoulder Belt
When not using the LATCH system, all child seats must be secured to the vehicle with the lap part of a lap/ shoulder belt. In addition, the lap/shoulder belts in all seating positions except ...Protecting Larger Children
When a child reaches the recommended weight or height limit for a forward-facing child seat, the child should sit in a back seat on a booster seat and wear the lap/ shoulder belt. The follo ...See also:
Ending a call
To finish the call, perform one of the following procedures:
- Select the Hang up key on the Call in Progress display.
- Push the switch on the
steering wheel.
- When the Call in Progres ...
Maintenance tools
Your vehicle is equipped with the following maintenance tools.
● Jack
● Jack handle
● Screwdriver
● Towing hook (eye bolt) (if equipped) . Wheel nut wrench
● Electro ...
Heater operation
Heating
This mode is used to direct heated air to the foot
outlets. Some air also flows from the defrost
outlets and the side vent outlets.
1. Press the button to the OFF
position
for normal h ...