Volvo S60: Erasing HomeLink Buttons
To erase programming from the three Home- Link buttons (individual buttons cannot be erased but can be “reprogrammed” as outlined below), follow the step noted:
1. Press and hold the two outer HomeLink buttons until the indicator light begins to flash-after 10 seconds.
2. Release both buttons. Do not hold for longer that 20 seconds.
HomeLink is now in the train (or learning) mode and can be programmed at any time beginning with “Programming” - step 1.
Using HomeLink
To operate, simply press and release the programmed HomeLink button. Activation
will now occur for the trained device (i.e., garage door opener, gate operator,
security system, entry door lock, ho ...
Reprogramming a Single HomeLink Button
To program a device to HomeLink using a HomeLink button previously trained, follow
these steps:
1. Press and hold the desired HomeLink button. DO NOT release the button.
2. The indicator light wil ...
See also:
Loose Filler Cap Message
If the vehicles diagnostic system determines that the fuel
filler cap in loose, improperly installed, or damaged, a
“gASCAP” message will be displayed in the instrument
cluster. Tighten the ...
Legacy
To fold down the seatback, perform the following procedure.
1. Open the trunk lid. Refer to “Opening the trunk lid (Legacy)” F2-9 or “To
open the trunk lid from inside” F2-24.
1) Release ...
2. Evaporative emission control (including ORVR: Onboard Refueling Vapor Recovery)
system
The Evaporative Emission Control System is designed to prevent fuel vapors from
escaping into the atmosphere. (The ORVR system is designed to allow the vapors from
the fuel tank to be loaded into ...
