Toyota Camry: Programming an entry gate (for U.S. owners)/Programming a
device in the Canadian market
- Place the remote control transmitter 1 to 3 in. (25 to 75 mm)
away from the HomeLink® buttons.
Keep the HomeLink® indicator light in view while programming. - Press and hold the selected HomeLink® button.
- Repeatedly press and release (cycle) the remote control transmitter for 2 seconds each until step 4 is completed.
- When the HomeLink® indicator light starts to flash rapidly, release the buttons.
- Test the HomeLink® operation by pressing the newly programmed button. Check to see if the gate/device operates correctly.
- Repeat the steps above to program another device for any of the remaining HomeLink® buttons.
Programming a Rolling Code system (for U.S. owners)
If your device is Rolling Code equipped, follow the steps under the
heading “Programming HomeLink®” before proceeding with the
steps listed below.
Locate the learn button on the ceiling m ...
Programming other devices
To program other devices such as home security systems, home
door locks or lighting, contact your Toyota dealer for assistance. ...
See also:
Opening and closing the side
windows
1. Front left
2. Front right
3. Rear right
4. Rear left
The switches for all side windows are located
on the driver's door. There is also a switch on
each door for the corresponding ...
Cruise control
Steering wheel-mounted controls and display
1 - Standby mode 2 - Resume set speed 3 - Deactivating 4 - Activate/set
speed 5 - Set speed indicator (parentheses indicate standby mode)
Engaging ...
If engine stalls while driving
1. Reduce your speed gradually, keeping a straight line. Move cautiously off
the road to a safe place.
2. Turn on your emergency flashers.
3. Try to start the engine again. If your vehicle will no ...
