Mercedes-Benz E-Class: Opening and closing the side 
windows - Side windows - Opening/closing - Mercedes-Benz E-Class Owners ManualMercedes-Benz E-Class: Opening and closing the side windows

1. Front left

1. Front left
2. Front right
3. Rear right
4. Rear left

The switches for all side windows are located on the driver's door. There is also a switch on each door for the corresponding side window.

The switches on the driver's door take precedence.

i The side windows cannot be operated from the rear when the override feature for the side windows is activated.

•► Turn the SmartKey to position 1 or 2 in the ignition lock.

•► To open: press the corresponding switch.

•► To close: pull the corresponding switch.

If you press the switch beyond the point of resistance, an automatic opening/ closing process is started in the corresponding direction. You can stop automatic operation by operating the switch again.

You can continue to operate the side windows after you switch off the engine or remove the SmartKey. This function is available for up to five minutes or until the driver's or front-passenger door is opened.

    Important safety notes
    WARNING When opening or closing the door windows, make sure that there is no danger of anyone being harmed by the opening/closing procedure. The door windows are equipped with automatic ...

    Convenience opening feature
    You can ventilate the vehicle before you start driving. To do this, the key is used to carry out the following functions simultaneously: - unlock the vehicle - open the side windows - ope ...

    See also:

    When CD is in the player (type A)/ When playing back all CDs in the player (type B)
    When the “CD/AUX” button is pressed, the player will start playback. ...

    Important safety notes
    You will find an illustration of the instrument cluster in the "At a glance" section WARNING A driver's attention to the road and traffic conditions must always be his/her primary ...

    Symbols
    The vehicle has components and labels that use symbols instead of text. Symbols are shown along with the text describing the operation or information relating to a specific component, control, message ...