Buick LaCrosse: Engine Coolant Temperature Warning Light - Warning Lights, Gauges, and Indicators - Instruments and Controls - Buick LaCrosse Owners ManualBuick LaCrosse: Engine Coolant Temperature Warning Light

For eAssist vehicles, this light

For eAssist vehicles, this light comes on briefly while starting the vehicle.

If it does not, have the vehicle serviced by the dealer. If the system is working normally, the indicator light goes off.

Notice:
Driving with the engine coolant temperature warning light on could cause the vehicle to overheat. See Engine Overheating. The vehicle's engine could be damaged, and it might not be covered by the vehicle warranty. Never drive with the engine coolant temperature warning light on.

The engine coolant temperature warning light comes on when the engine has overheated.

If this happens pull over and turn off the engine as soon as possible. See Engine Overheating for more information.

    Traction Control System (TCS)/StabiliTrak® Light
    The Traction Control System (TCS)/StabiliTrak light comes on briefly when the engine is started. If the light does not come on, have the vehicle serviced by the dealer. If the system is workin ...

    Tire Pressure Light
    For vehicles with the Tire Pressure Monitor System (TPMS), this light comes on briefly when the engine is started. It provides information about tire pressures and the TPMS. ...

    See also:

    Auxiliary Input Jack
    The auxiliary input jack is inside the console compartment. The system will accept auxiliary input from standard audio accessories using a 1/8 inch (3.5 mm) stereo miniplug. When you plug i ...

    If the battery is discharged
    The following procedures may be used to start the engine if the vehicle's battery is discharged. You can also call your Toyota dealer or a qualified repair shop. If you have a set of jumper (or bo ...

    Changing the batteries
    CAUTION ● Do not let dust, oil or water get on or in the remote engine start transmitter when replacing the battery. ● Be careful not to damage the printed circuit board in the remote ...