Mercedes-Benz E-Class: Warning and display messages in the 
multifunction display - ATTENTION ASSIST - Driving systems - Driving and parking - Mercedes-Benz E-Class Owners ManualMercedes-Benz E-Class: Warning and display messages in the multifunction display

•► Activate ATTENTION ASSIST using the onboard

•► Activate ATTENTION ASSIST using the onboard computer

Symbol 1 appears in the multifunction display.

If ATTENTION ASSIST is active, you will be warned no sooner than 20 minutes after your journey has begun. You will then hear an intermittent warning tone twice, and the Attention Assist: Time for a rest? message appears in the multifunction display.

•► If necessary, take a break.
•► Press On long journeys, take regular breaks in good to confirm the message.

On long journeys, take regular breaks in good time to allow yourself to rest properly. If you do not take a break and ATTENTION ASSIST still detects typical indicators of fatigue or increasing lapses in concentration, you will be warned again after 15 minutes at the earliest.

ATTENTION ASSIST is reset when you continue your journey and starts assessing your tiredness again if:

 - you switch off the engine.
 - you take off your seat belt and open the driver's door, e.g. for a change of drivers or to take a break.

    Important safety notes
    ATTENTION ASSIST helps you during long, monotonous journeys such as on freeways and interstate highways. It is active in the range between 50 mph (80 km/h) and 112 mph (180 km/h). If ATTENTIO ...

    See also:

    Manual operation (if so equipped)
     Tilt and telescopic operation Pull the lock lever (1) all the way towards you: - Adjust the steering wheel forward or backward in direction (2)- to the desired position. - Adjust the st ...

    Windshield wiper and washer switch
     Windshield wiper and washer switch The windshield wiper and washer operates when the ignition switch is in the ON position. Push the lever down to operate the wiper at the following spee ...

    Replacing Rear Bulbs
    1. Open the trunk. Remove the screws in the center of each of the two fasteners on the side of the trunk lining. Pull the lining back. 2. Determine which of the three bulbs is burned out: ...