Nissan Altima: To protect your vehicle from corrosion - Corrosion protection - Appearance and care - Nissan Altima Owners ManualNissan Altima: To protect your vehicle from corrosion

● Wash and wax your vehicle often to keep the vehicle clean.
● Always check for minor damage to the paint and repair it as soon as possible.
● Keep drain holes at the bottom of the doors open to avoid water accumulation.
● Check the underbody for accumulation of sand, dirt or salt. If present, wash with water as soon as possible.

CAUTION

● NEVER remove dirt, sand or other debris from the passenger compartment by washing it out with a hose. Remove dirt with a vacuum cleaner or broom.
● Never allow water or other liquids to come in contact with electronic components inside the vehicle as this may damage them.

Chemicals used for road surface de-icing are extremely corrosive. They accelerate corrosion and deterioration of underbody components such as the exhaust system, fuel and brake lines, brake cables, floor pan and fenders.

In winter, the underbody must be cleaned periodically.

For additional protection against rust and corrosion, which may be required in some areas, consult a NISSAN dealer.

Air pollution
Industrial pollution, the presence of salt in the air in coastal areas, or heavy road salt use accelerates the corrosion process. Road salt also accelerates the disintegration of paint surfaces. ...

License plate bracket padding
1. License plate 2. Trunk 3. License plate frame 4. Padding CAUTION A license plate frame could vibrate and cause noise or paint damage. To avoid damage or noise, add a soft adhesive pad wit ...

See also:

Switch operation
The windshield wiper and washer switch operates when the ignition switch is placed in the ON position. Push the lever down to operate the wiper at the following speed: 1 Intermittent — interm ...

Ride Control System Messages
ALL WHEEL DRIVE OFF This message displays when the All-Wheel Drive (AWD) System has been turned off. See All-Wheel Drive. SERVICE ALL WHEEL DRIVE SYSTEM This message displays when there i ...

Adjusting the Power Mirrors
1. Turn the ignition switch to the ON (II) position. 2. Move the selector switch to L (driver’s side) or R (passenger’s side). 3. Push the appropriate edge of the adjustment switch to ...