Subaru Legacy: Sliding moonroof
1) Open
2) Close
Press the “OPEN/CLOSE” switch rearward to open the moonroof. The sun shade will also be opened together with the moonroof. For Outback, the moonroof will stop at a position approximately 0.8 in (2 cm) away from the fully opened position. Press the switch again to open the moonroof completely.
Press the “OPEN/CLOSE” switch forward to close the moonroof. To stop the moonroof at a selected midway position while opening or closing it, momentarily press the switch to the “OPEN” side or “CLOSE” side. After washing the vehicle or after it rains, wipe away water on the roof prior to opening the moonroof to prevent drops of water from falling into the passenger compartment.
NOTE
● For the sake of safety, it is recommended that you avoid driving with the moonroof
fully opened.
● If the moonroof cannot be closed through the switch operation because of system
failure, it can be closed manually using a hex-head wrench. For the procedure, refer
to “Moonroof
– if moonroof cannot be closed” F9-19.
Tilting moonroof
1) Raise
2) Lower
The raising function will only operate when the moonroof is fully closed. The
lowering function will only operate when the moonroof is raised.
Press the rear side of the “UP ...
Anti-entrapment function
When the moonroof senses a substantial enough object trapped between its glass
and the vehicle’s roof during closure, it automatically moves back to the fully
open position and stops there. The ...
See also:
Pulling a stuck vehicle
WARNING
To avoid vehicle damage, serious personal
injury or death when recovering a
stuck vehicle:
● Contact a professional towing service
to recover the vehicle if you have any
questions ...
How to use this manual
We want to help you get the greatest possible driving pleasure from your vehicle.
Your Owner’s Manual can assist you in many ways. We strongly recommend that you
read the entire manual. In order ...
Compass display (if so equipped)
This unit measures terrestrial magnetism and indicates
the direction of the vehicle’s heading.
With the ignition switch placed in the ON position,
press the button as described in
the
chart b ...
