Subaru Legacy: Shift lock release using the shift lock release button
Perform the following procedure to release the shift lock.
1. Apply the parking brake and stop the engine.
2. Remove the shift lock cover using a flat-head screwdriver.
3. While depressing the brake pedal, insert the electronic parking brake release tool into the hole, press the shift lock release button using the tool, and then move the select lever.
NOTE
To prevent damage to the shift lock cover, cover the tip of the flat-head screwdriver with vinyl tape or a cloth before removing the cover.
If the select lever does not move after performing the above procedure, the shift lock system may be malfunctioning. Contact a SUBARU dealer for an inspection as soon as possible.
Shift lock release
If the select lever cannot be operated, turn the ignition switch back to the “ON” position then move the select lever to the “P” position with the select lever button pressed and brake ped ...Selection of manual mode
With the vehicle either moving or stationary, move the select lever from the “D” position to the “M” position to select the manual mode. 1) Upshift indicator 2) Downshift indicator 3) ...See also:
Heated seats
Driver side
Passenger side
CAUTION:
Operating the heated seats with theengine off will drain the battery.
The heated seats will operate when theignition switch is in position II. ...
Getting started
Voice control button on the steering wheel ...
Driver Information Center (DIC)
The Driver Information Center (DIC)
displays information about the
vehicle. It also displays warning
messages if a system problem is
detected. See Vehicle Messages for more information. All
...