Kia Optima: Road warning
Hazard warning flasher
The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle.
It should be used whenever emergency repairs are being made or when the vehicle is stopped near the edge of a roadway.
Depress the flasher switch with the ignition switch in any position. The flasher switch is located in the center console switch panel. All turn signal lights will flash simultaneously.
• The hazard warning flasher operates whether your vehicle is running or not.
• The turn signals do not work when the hazard flasher is on.
• Care must be taken when using the hazard warning flasher while the vehicle is being towed.
In case of an emergency while driving
If the engine stalls at a crossroad or crossing
• If the engine stalls at a crossroad or crossing, set the shift lever in the
N (Neutral) position and then push the vehicle to a safe place.
• ...
See also:
Pre-towing tips
● Be certain your vehicle maintains a level
position when a loaded and/or unloaded
trailer is hitched. Do not drive the vehicle if it
has an abnormal nose-up or nose-down
condition; check fo ...
Uniform Tire Quality Grading
This information has been prepared in accordance with regulations
issued by the National Highway Traffic Safety Administration of the
U.S. Department of Transportation.
It provides the purchasers ...
System operation
The automatic drive positioner system will not work or will stop operating under
the following conditions:
- When the vehicle speed is above 4 MPH (7 km/h).
- When any of the memory switches are p ...
