Mercedes-Benz E-Class: Releasing seat belts
- Press release button 4 and guide belt tongue ; back towards belt sash guide 1.
Make sure that the seat belt is fully rolled up. Otherwise, the seat belt or belt tongue will be trapped in the door or in the seat mechanism. This could damage the door, the door trim panel and the seat belt.
Damaged seat belts can no longer fulfill their protective function and must be replaced. Consult an authorized Mercedes- Benz Center.
Using the rear center seat belt
If the left-hand rear seat backrest is folded down and back up again, the rear center seat belt may lock. The seat belt can then not be pulled out. To release the rear center seat belt:pull o ...Belt warning for the driver and front passenger
Regardless of whether the driver and front passenger have fastened their seat belts already, the seat belt warning lamp lights up for 6 seconds after every engine start. It then goes out if t ...See also:
Active chassis (Four C)
Active chassis, Four-C (Continuously Controlled Chassis Concept), regulates the
characteristics of the shock absorbers so that the car's driving characteristics
can be adjusted. There are thre ...
Unfastening the front seatbelt
Push the button on the buckle.
Before closing the door, make sure that the belts are retracted properly to avoid
catching the belt webbing in the door. ...
MUTE button (if equipped)
Press this button if you wish to immediately cut the volume to zero.
The audio display will show “MUTE”. If you press the button again, the original
sound volume will return and “MUTE” tu ...