Subaru Legacy: Rear wiper
To turn the rear wiper on, turn the knob on the end of the wiper control lever upward to the “INT” or “ON” position. To turn the wiper off, return the knob on the end of the lever to the “OFF” position. With the switch turned to the “INT” position, the rear wiper will operate intermittently at intervals corresponding to the vehicle speed.
When you subsequently move the select lever to the “R” position (AT and CVT models) or the shift lever to the reverse position (MT models), the rear wiper will switch to continuous operation. When you move the select lever/shift lever from the “R” (reverse) position to another position, the rear wiper will return to intermittent operation.
Rear window wiper and washer switch (Outback)
: Washer (accompanied by wiper operation) ON: Continuous INT: Intermittent OFF: Off : Washer (accompanied by wiper operation) ...Washer
To wash the rear window while the rear wiper is operating, turn the knob on the end of the wiper control lever upward to the “” position. The washer fluid sprays until you release the knob. To ...See also:
Selecting the Right Engine Oil
Selecting the right engine oil
depends on both the proper oil
specification and viscosity grade.
See Recommended Fluids and
Lubricants.
Specification
Use and ask for licensed engine oils
wi ...
Passenger’s frontal airbag ON and OFF indicators
The front passenger’s frontal airbag ON and OFF indicators show you the status
of the front passenger’s SRS frontal airbag. The indicators are located next to
the clock in the center porti ...
Vehicles with manual transmission
•► Shift to either first gear or reverse gear R.•► Turn the SmartKey to position 0 in the
ignition lock and remove it.
The immobilizer is activated.•► Apply the parking b ...