Subaru Legacy: Rear window wiper blade rubber (Outback)
1. Pull out the end of the blade rubber assembly to unlock it from the plastic support.
2. Pull the blade rubber assembly out of the plastic support.
1) Metal spines
3. If the new blade rubber is not provided with two metal spines, remove the metal spines from the old blade rubber and install them in the new blade rubber.
4. Align the claws of the plastic support with the grooves in the blade rubber assembly, then slide the blade rubber assembly into place.
Securely retain both ends of the rubber with the stoppers on the plastic support ends. If the rubber is not retained properly, the wiper may scratch the rear window glass.
5. Install the wiper blade assembly to the wiper arm. Make sure that it locks in place.
6. Hold the wiper arm by hand and slowly lower it in position.
Rear window wiper blade assembly (Outback)
1. Raise the wiper arm off the rear window.
2. Turn the wiper blade assembly counterclockwise.
3. Pull the wiper blade assembly toward you to remove it from the wiper arm. ...
Battery
WARNING
● Before beginning work on or near any battery, be sure to extinguish all cigarettes,
matches, and lighters. Never expose a battery to an open flame or electric sparks.
Batteries gi ...
See also:
Installation
1. Lower the battery into the battery box.
2. Move the battery inward and to the side until it reaches the rear edge of
the box.
3. Tighten the clamp that secures the battery.
4. Connect the ve ...
Rear seat
Headrest
The rear seat(s) is equipped with headrests in all the seating positions for
the occupant's safety and comfort.
The headrest not only provides comfort for passengers, but also helps t ...
Trunk Internal Emergency Release
As a security measure, a Trunk Internal Emergency
Release lever is built into the trunk latching mechanism.
In the event of an individual being locked inside the
trunk, the trunk can be simply op ...
