Subaru Legacy: Rear window side seating position
1) Head restraint 2) Release button
To raise:
Pull the head restraint up.
To lower:
Push the head restraint down while pressing the release button on the top of the
seatback.
To remove:
While pressing the release button, pull out the head restraint.
To install:
Install the head restraint into the holes that are located on the top of the seatback
until the head restraint locks.
The head restraint should be adjusted so that the center of the head restraint is closest to the top of the occupant’s ears. When the seats are not occupied, lower the head restraints to improve rearward visibility.
NOTE
For Legacy, it is not possible to remove or install the head restraint without folding down the rear seatback. Fold down the rear seatback and then remove or install the head restraint.
Head restraint adjustment
Both the rear window side seats and the rear center seat are equipped with head restraints. WARNING ● Never drive the vehicle with the head restraints removed because they are designed to ...Rear center seating position
CAUTION The head restraint is not intended to be used at the lowest position. Before sitting on the seat, raise the head restraint to the extended position. A) When not used (retracted position) ...See also:
Information in detail
Range
Displays the estimated cruising range available
with the remaining fuel.
It is calculated based on your driving style over
the last 20 miles/30 km.
If there is only enough fuel left for l ...
Interior overview
Door lock/unlock button
Outside rearview mirror control switch
Central door lock switch
Power window lock switch
Power window switches
Hood release lever
Parking brake*
Instrument p ...
Tether anchorage location
Legacy
Three tether anchorages are installed on the rear shelf behind the rear seat
head restraint. Open the cover flap to use each anchorage.
Outback
Three tether anchorages, i.e., ones for ...