Subaru Legacy: Map light - Replacing bulbs - Maintenance and service - Subaru Legacy Owners ManualSubaru Legacy: Map light

1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.

1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.

2. Turn the bulb until the flat surfaces at its ends are aligned vertically.

2. Turn the bulb until the flat surfaces at its ends are aligned vertically. Pull the bulb straight downward to remove it.

3. Install a new bulb.

4. Reinstall the lens.

    Dome light
    1. Remove the lens by prying the edge of the lens with a flat-head screwdriver. 2. Turn the bulb until the flat surfaces at its ends are aligned vertically. 3. Pull the bulb straight downward to ...

    Vanity mirror light
    1. Remove the lens by prying the edge of the lens with a flat-head screwdriver. 2. Pull the bulb out of the socket. 3. Install a new bulb. 4. Reinstall the lens. ...

    See also:

    NISSAN Voice Recognition Standard Mode
    The Standard Mode enables control of navigation, phone and vehicle information. With this setting active, commands that are available are always shown on the display and announced by the system. ...

    Tyre repair kit
    Your vehicle may not have a spare tyre. In this case it will have an emergency tyrerepair kit that can be used to repair oneflat tyre. The tyre repair kit is located in the sparewheel well. General ...

    Seats
    Seats are a primary part of the Occupant Restraint Systemof the vehicle. They need to be used properly for safeoperation of the vehicle. WARNING: • DO NOT allow people to ride in any area of you ...