Mercedes-Benz E-Class: installing and removing the seat cushion
You must remove the seat cushion if you wish to lift the trunk floor, e.g. if the vehicle has a flat tire.
•► To remove: fold seat cushion 2 upwards and remove it from seat cushion guides 1.
•► To install: guide seat cushion 2 into seat cushion guides 1 at a slight angle from the rear 3.
•► Fold seat cushion 2 back into its original position 4 until it engages.
Folding out the folding bench seat
•► Make sure that the backrests of the rear bench seat are locked in the upright position. •► Move the handle for the combined cargo cover and net upwards. •► Pull re ...Folding back the folding bench seat
•► Pull the seat cushion upwards by tab 1 and fold it back into its original position until it engages. •► Press release button 1 and fold the head restraints down. In orde ...See also:
Immobilizer system
This light blinks approximately 60 seconds after the ignition switch is turned
from “ON” position to the “Acc” or “LOCK” position or immediately after the key
is pulled out. Refer to ...
Vehicle Locator Lights
This allows the vehicle locator lights
to be turned on or off. The vehicle
locator lights come on when
unlocking the vehicle with the RKE
transmitter.
Press SELECT when Vehicle
Locator Ligh ...
NISSAN dealer.
However, now and then you may notice
light spark knock for a short time while
accelerating or driving up hills. This is not a
cause for concern, because you get the
greatest fuel benefit when ther ...