Nissan Maxima: If your vehicle is stolen
If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLink. Consult the Owners Manual of each device or call the manufacturer or dealer of those devices for additional information.
When your vehicle is recovered, you will need to reprogram the HomeLink Universal Transceiver with your new transmitter information.
FCC Notice:
This device complies with FCC rules part 15 and RSS-210 of Industry Canada. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and (2) This device must accept any interference that may be received, including interference that may cause undesired operation.
This transmitter has been tested and complies with FCC and DOC/MDC rules.
Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.
DOC: ISTC 1763K1313.
FCC I.D. CV2V67690.
Reprogramming a single HomeLink button
To reprogram a HomeLink Universal Transceiver button, complete the following.
1. Press and hold the desired HomeLink button.
Do not release the button until step 4 has been completed.
2. When the i ...
See also:
Precautions on supplemental restraint system
This Supplemental Restraint System (SRS) section contains important information
concerning the following systems:
- Driver and passenger supplemental frontimpact air bag (NISSAN Advanced Air
Bag. ...
Fuel pump shut off system
To minimize the risk of fuel leakage when the engine stalls or when
an airbag inflates upon collision, the fuel pump shut off system
stops the supply of fuel to the engine.
Follow the procedure b ...
Re-installing the wheel
1. Clean the contact surfaces on the wheel and hub.
2. Lift the wheel and place it on the hub.
Tighten the lug nuts
3. Install the wheel nuts and tighten handtight. Using the lug wrench, tighten ...
