Subaru Legacy: How to use as crossbars
CAUTION
● Do not raise the bar higher than necessary. The base of the bar may be damaged.
● Be careful not to contact the bars while sliding them. Otherwise, the bars may
be scratched or the latch portions may be damaged.
● Do not slide the bar more than necessary when sliding the bar. The base of the
bar may be damaged.
● Do not allow the bar to fall on or contact the roof panel or the moonroof when
sliding the bar. Otherwise the roof panel may be dented or the glass of the moonroof
may be damaged.
1. Pull out the integrated crossbars from the roof rail holders by pulling up the covers.
2. Slide the bars in the direction shown in the illustration.
3. Install the bars into the holders.
4. Make sure that the latches are fitted securely.
Installing carrying attachments on the crossbars
When installing any carrying attachment such as a bike carrier, ski carrier, kayak carrier, cargo basket, etc. on the crossbars, follow the manufacturer’s instructions and make sure that the att ...How to re-stow bars
CAUTION Do not use the bars as roof rails when the bars are stowed. 1. Pull out the crossbars from the roof rail holders by pulling up the covers. 2. Slide the bars in the direction shown in th ...See also:
Window Messages
OPEN, THEN CLOSE DRIVER WINDOW
This message is displayed when the window needs to be reprogrammed.
If the vehicle's battery has been recharged or disconnected, you will need to reprogram each front ...
Check TPMS Warning
When a system fault is detected, a chime will sound and
the “Tire Pressure Monitoring Telltale Light” will flash on
and off for 75 seconds and then remain on solid. In
addition, the EVIC wil ...
Cleaning the Display
Notice:
Using abrasive cleaners
when cleaning glass surfaces
could scratch the glass. Use only
a soft cloth and do not spray
cleaner directly on the system as
it could affect the mechanical ...