Nissan Maxima: Heated seats (if so equipped)
The front seats are warmed by built-in heaters.
The switch is located on the center console.
1. Start the engine.
2. Push the LO or HI position of the switch, as desired. The indicator light in the switch will illuminate.
The heater is controlled by a thermostat, automatically turning the heater on and off.
The indicator light will remain on as long as the switch is on.
3. When the seat is warmed or before you leave the vehicle, be sure to turn the switch off.
CAUTION:
- Do not use the seat heater for extended periods or when no one is using the seat.
- Do not put anything on the seat which insulates heat, such as a blanket, cushion, seat cover, etc. Otherwise, the seat may become overheated.
- Do not place anything hard or heavy on the seat or pierce it with a pin or similar object. This may result in damage to the heater.
- Any liquid spilled on the heated seat should be removed immediately with a dry cloth.
- When cleaning the seat, never use gasoline, benzine, thinner, or any similar materials.
- If any abnormalities are found or the heated seat does not operate, turn the switch off and have the system checked by your NISSAN dealer.
- The battery could run down if the seat heater is operated while the engine is not running.
Climate control seat switch (if so equipped)
The climate controlled seat warms up or cools down the front seat by blowing warm or cool air from the surface of the seat. The climate control switch is located on the center console. The clim ...Heated steering wheel (if so equipped)
The heated steering wheel system is designed to operate only when the surface temperature of the steering wheel is below 68°F (20°C). Push the heated steering wheel switch to warm the steering ...See also:
Gear Ranges
DO NOT race the engine when shifting from PARK or
NEUTRAL into another gear range. ...
Compass Messages
CAL
This message is displayed when the
compass needs to be calibrated.
See Compass.
– – –
Three dashes will be displayed if the
compass needs service. See your
dealer for service. ...
Function check
All indicator and warning symbols light up in ignition mode II or when the engine
is started. When the engine has started, all the symbols should go out except the
parking brake symsymbol, which o ...