Nissan Maxima: Headlights
Replacing the xenon headlight bulb (if so equipped)
HIGH VOLTAGE:
When xenon headlights are on, they produce a high voltage. To prevent an electric shock, never attempt to modify or disassemble.
Always have your xenon headlights replaced at a NISSAN dealer. For additional information, see Headlight and turn signal switch in the Instruments and controls section.
Replacing the halogen headlight bulb (if so equipped)
The headlight is a semi-sealed beam type which uses a replaceable headlight (halogen) bulb. Because the headlight assembly must be removed from the vehicle for bulb replacement, see your NISSAN dealer.
CAUTION:
- Aiming is not necessary after replacing the bulb. When aiming adjustment is necessary, contact a NISSAN dealer.
- Do not leave the headlight assembly open without a bulb installed for a long period of time. Dust, moisture, smoke, etc. entering the headlight body may affect bulb performance. Remove the bulb from the headlight assembly just before a replacement bulb is installed.
- Only touch the base when handling the bulb. Never touch the glass envelope.
Touching the glass could significantly affect bulb life and/or headlight performance.
- High pressure halogen gas is sealed inside the halogen bulb. The bulb may break if the glass envelope is scratched or the bulb is dropped.
Fog may temporarily form inside the lens of the exterior lights in the rain or in a car wash. A temperature difference between the inside and the outside of the lens causes the fog. This is not a malfunction. If large drops of water collect inside the lens, contact a NISSAN dealer.
NISSAN Intelligent Key
Replace the battery in the Intelligent Key as follows:
1. Remove the mechanical key from the Intelligent Key.
2. Insert a small screwdriver (A) into the slit (B)- of the corner and twist
it to sep ...
Exterior and interior lights
* Always check with the Parts Department at a NISSAN dealer for the latest parts
information.
1. Headlight assembly.
2. Map light.
3. Rear personal lights.
4. Fog light (if so equippe ...
See also:
Removal
Use the following procedure to remove the adjustable
head restraints.
1. Pull the head restraint up to the highest
position.
2. Push and hold the lock knob and release
knob.
3. Remove the head ...
Selecting a channel category
1. Turn TUNE to display a list of channels.
2. Press EXIT.
3. Turn TUNE to scroll through the list of categories and press OK/MENU to make
a selection.
> The channels in the selected category ...
Playing back MP3 and WMA discs
Loading and ejecting MP3 and WMA discs ...
