Buick LaCrosse: Gate Operator and Canadian
Programming
If you have questions or need help programming the Universal Remote system, call 1-800-355-3515 or go to www.homelink.com.
Canadian radio-frequency laws require transmitter signals to time out or quit after several seconds of transmission. This may not be long enough for the Universal Remote system to pick up the signal during programming. Similarly, some U.S.
gate operators are manufactured to time out in the same manner.
If you live in Canada, or you are having difficulty programming a gate operator or garage door opener by using the “Programming the Universal Remote System” procedures, regardless of where you live, replace Step 2 under “Programming the Universal Remote System” with the following:
Continue to press and hold the Universal Remote system button while you press and release every two seconds (cycle) the hand-held transmitter button until the frequency signal has been successfully accepted by the Universal Remote system. The Universal Remote system indicator light will flash slowly at first and then rapidly. Proceed with Step 3 under “Programming the Universal Remote System” to complete.
Programming the Universal
Remote System
For questions or help programming
the Universal Remote system, call
1-800-355-3515 or go to
www.homelink.com.
Programming a garage door opener
involves time-sensitive actions, so
read the e ...
See also:
Repeat play
Pressing (RPT) changes modes in
the following order:
File repeat → Folder repeat* → Off.
*: Available except when RDM (random playback) is selected ...
Door locks
Operating door locks from outside the vehicle
• Turn the key toward the rear of the vehicle to unlock and toward the front
of the vehicle to lock.
• If you lock the door with a key, all vehi ...
Checking the coolant level
Only check the coolant level when the vehicle
is on a level surface and the engine has cooled
down.
Turn the SmartKey to position
2 in the ignition lock.
On vehicles with KEYLESS-GO, press the ...
