Subaru Legacy: Front seatbelts
1. Adjust the seat position:
Driver’s seat: Adjust the seatback to the upright position. Move the seat as far from the steering wheel as practical while still maintaining full vehicle control. Front passenger’s seat: Adjust the seatback to the upright position. Move the seat as far back as possible.
2. Sit well back in the seat.
3. Pick up the tongue plate and pull the belt out slowly. Do not let it get twisted. If the belt stops before reaching the buckle, return the belt slightly and pull it out more slowly. If the belt still cannot be unlocked, let the belt retract slightly after giving it a strong pull, then pull it out slowly again.
4. Insert the tongue plate into the buckle until you hear a click.
5. To make the lap part tight, pull up on the shoulder belt.
6. Place the lap belt as low as possible on your hips, not on your waist.
Fastening the seatbelt
WARNING
● Never use a belt that is twisted or reversed. In an accident, this can increase
the risk or severity of injury.
● Keep the lap belt as low as possible on your hips. In a coll ...
Adjusting the front seat shoulder belt anchor height
The shoulder belt anchor height should be adjusted to the position best suited
for the driver/front passenger. Always adjust the anchor height so that the shoulder
belt passes over the middle of ...
See also:
Glove box lamp
When the ignition key is in the ignition switch, the smart key is in the smart
key holder or the engine start/stop button is in the ACC position, if the glove
box is opened, the glove box lamp w ...
Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher
than the bottom of the wheel hub. Drive through any water slowly. Allow adequate
stopping distance because brake perf ...
Driver Information Center (DIC)
The Driver Information Center (DIC)
displays information about the
vehicle. It also displays warning
messages if a system problem is
detected. See Vehicle Messages for more information. All
...
