Subaru Legacy: ECO gauge - Meters and gauges - Instruments and controls - Subaru Legacy Owners ManualSubaru Legacy: ECO gauge

1) U.S.-spec. models

1) U.S.-spec. models
2) Except U.S.-spec. models

The ECO gauge shows the difference between the average rate of fuel consumption and the current rate of fuel consumption. Using the average rate of fuel consumption since the trip meter was last reset, the indicator needle behaves as described in the following items.

U.S.-spec. models:

If the current rate of fuel consumption is lower than the average rate of fuel consumption, the indicator needle points to the “+” side. If the current rate of fuel consumption is higher than the average rate of fuel consumption, the indicator needle points to the “−” side. When the indicator needle is pointing to the “+” side, it indicates fuel-efficient driving.

Except U.S.-spec. models:

If the current rate of fuel consumption is lower than the average rate of fuel consumption, the indicator needle points to the “−” side. If the current rate of fuel consumption is higher than the average rate of fuel consumption, the indicator needle points to the “+” side. When the indicator needle is pointing to the “−” side, it indicates fuel-efficient driving.

NOTE

● The ECO gauge shows only an approximate indication.
● After resetting the trip meter, the average rate of fuel consumption is not shown until driving 0.6 mile (1 km). Until that time, the ECO gauge does not operate.

    Low fuel warning light
    The low fuel warning light illuminates when the fuel tank is nearly empty. It only operates when the ignition switch is in the “ON” position. When this light illuminates, fill the fuel tank im ...

    Warning and indicator lights
    Several of the warning and indicator lights illuminate momentarily and then go out when the ignition switch is initially turned to the “ON” position. This permits checking the operation of the ...

    See also:

    Height Adjustment
    Height Adjustment Press and hold the top or bottom of the switch to raise or lower the seat. Release the switch when the desired height is reached. ...

    Video playback
    Country codes Only DVDs with the code of the home region can be played back; also refer to the information on the DVD. Playback The video image is displayed on the front Control Display u ...

    To decrease the speed (by brake pedal)
    1. Depress the brake pedal to release cruise control temporarily. 2. When the speed decreases to the desired speed, press the “RES/SET” switch to the “SET” side once. Now the desired speed ...