Nissan Altima: Control buttons
The control buttons for the Bluetooth Hands- Free Phone System are located on the steering wheel.
PHONE/SEND
Press the button to initiate a VR session or answer an incoming call.
You can also use the button to interrupt the system feedback and give a command at once. See “List of voice commands” and “During a call” in this section for more information.
PHONE/END
While the voice recognition system is active, press and hold the button for 5 seconds to quit the voice recognition system at any time.
TUNING SWITCH
While using the voice recognition system, tilt the tuning switch up or down to manually control the phone system.
Giving voice commands
To operate NISSAN Voice Recognition, press and release the button located on the steering wheel. After the tone sounds, speak a command. The command given is picked up by the microphone, and v ...Getting started
The following procedures will help you get started using the Bluetooth Hands-Free Phone System with NISSAN Voice Recognition. For additional command options, refer to “List of voice commands” ...See also:
Power-Up
After switching the ignition key from OFF to either the
ON or ACC position, or after a language change, you
must wait at least fifteen seconds prior to using the
system.
...
Operating tips
-When the engine coolant temperature and outside air temperature are low, the
air flow from the foot outlets may not operate for a maximum of 150 seconds. However,
this is not a malfunction. Aft ...
Important safety notes
WARNING
In order to avoid possible loss of vehicle
control, all seat, head restraint, steering
wheel and rear view mirror adjustments, as
well as fastening of seat belts, must be done
bef ...