Subaru Legacy: Checking the oil level - Manual transmission oil - Maintenance and service - Subaru Legacy Owners ManualSubaru Legacy: Checking the oil level

Non-turbo models

Non-turbo models
1) Yellow handle

Turbo models

Turbo models

1) Yellow handle

Check the oil level monthly.

1. Park the vehicle on a level surface and stop the engine.

2. Pull out the level gauge, wipe it clean, and insert it again.

1) Upper level

1) Upper level
2) Lower level

3. Pull out the level gauge again and check the oil level on it. If it is below the lower level, add oil through the level gauge hole to bring the level up to the upper level.

CAUTION

Be careful not to spill manual transmission oil when adding it. If oil touches the exhaust pipe, it may cause a bad smell, smoke, and/or a fire. If oil gets on the exhaust pipe, be sure to wipe it off.

    Recommended grade and viscosity
    Each oil manufacturer has its own base oils and additives. Never use different brands together. For details, refer to “Manual transmission, front differential and rear differential gear oil” F ...

    See also:

    Operation
    1) Driver’s side 2) Passenger’s side The SRS airbag can function only when the ignition switch is in the “ON” position. The SUBARU advanced frontal airbag system is designed to determine ...

    Toggling Between Calls
    If two calls are in progress (one active and one on hold), press the button until you hear a single beep, indicating that the active and hold status of the two calls have switched. Only one c ...

    Ignition off
    Automatic transmission: press the Start/Stop button again, and do not press on the brake pedal at the same time. Manual-shift transmission: press the Start/Stop button again, and do not press o ...