Subaru Legacy: Checking the coolant level
Check the coolant level at each fuel stop.
1. Check the coolant level on the outside of the reservoir while the engine is
cool.
2. If the level is close to or lower than the “LOW” level mark, add coolant up to
the “FULL” level mark. If the reserve tank is empty, remove the radiator cap and
refill as required.
3. After refilling the reserve tank and the radiator, reinstall the caps and check
that the rubber gaskets inside the radiator cap are in the proper position.
Check the coolant level at each fuel stop.
1. Check the coolant level on the outside of the reservoir while the engine is
cool.
2. If the level is close to or lower than the “LOW” level mark, add coolant up to
the “FULL” level mark. If the reserve tank is empty, remove the radiator cap and
refill as required.
3. After refilling the reserve tank and the radiator, reinstall the caps and check
that the rubber gaskets inside the radiator cap are in the proper position.
CAUTION
● Be careful not to spill engine coolant when adding it. If coolant touches the exhaust pipe, it may cause a bad smell, smoke, and/or a fire. If engine coolant gets on the exhaust pipe, be sure to wipe it off.
● Do not splash the engine coolant over painted parts. The alcohol contained in the engine coolant may damage the paint surface.
Engine coolant
...
Changing the coolant
WARNING
Never attempt to remove the radiator cap until the engine has been shut off and
has cooled down completely. Since the coolant is under pressure, you may suffer
serious burns from a spray ...
See also:
Root Directory
The root directory is treated as a
folder. All files contained directly
under the root directory are
accessed prior to any root directory
folders. ...
Safety Locks
The vehicle may have power safety locks or manual safety locks. Power safety locks will lock the rear windows and not allow the rear doors to be opened from the inside.
Manual safety locks do not all ...
Cruise control lever
1. To store the current speed or a higher
speed
2. To store the current speed or a lower
speed
3. To deactivate DISTRONIC PLUS
4. To store the current speed or to call up
the last ...
