BMW 5 Series: Changing, maintaining, and storing the speed - Active Cruise Control with Stop & Go function, ACC - Driving comfort - Controls - BMW 5 Series Owners ManualsBMW 5 Series: Changing, maintaining, and storing the speed

The rocker switch can be pressed while the system is interrupted to maintain and store the current speed. DSC Dynamic Stability Control is switched on, if necessary.

Adapt the desired speed to the road conditions Adapting the desired speed
Adapt the desired speed to the road conditions and be ready to brake at all times; otherwise, there is the danger of an accident occurring.◀

Great speed differences with vehicles Speed differences
Great speed differences with vehicles driving ahead of you, e.g., when rapidly approaching a truck or when another vehicle swerves into your own lane, cannot be compensated for by the system.◀

Press the rocker switch up or down repeatedly

Press the rocker switch up or down repeatedly until the desired speed is set.

If active, the displayed speed is stored and the vehicle reaches the stored speed if the road is clear.

▷ Each time the rocker switch is pressed to the point of resistance, the desired speed increases or decreases by approx. 1 mph/ 1 km/h.

▷ Each time the rocker switch is pressed past the point of resistance, the desired speed increases or decreases by a maximum of 5 mph/10 km/h. Max. adjustable speed:

110 mph/180 km/h.

Hold the rocker switch in position to repeat the action.

    Maintaining/storing the speed
    Press the button. When the system is switched on, the current speed is maintained and stored as the desired speed. It is displayed in the speedometer and briefly displayed in the instrument c ...

    Distance
    Selecting a distance Adjust the distance according to the traffic and weather conditions; otherwise, there is the danger of an accident occurring. Maintain the prescribed safety distance.φ ...

    See also:

    Viewing range on the screen
    Range of view Range of view Image from camera The area from the rear end of the bumper can be viewed. Areas at both ends of the bumper and areas just under the bumper cannot be viewed. Als ...

    Programming a Rolling Code system (for U.S. owners)
    If your device is Rolling Code equipped, follow the steps under the heading “Programming HomeLink®” before proceeding with the steps listed below. Locate the learn button on the ceiling m ...

    Underbody Maintenance
    Use plain water to flush dirt and debris from the vehicle's underbody. Your dealer or an underbody car washing system can do this. If not removed, rust and corrosion can develop. ...