Subaru Legacy: Automatic release function by accelerator pedal
The electronic parking brake system has an automatic release function. The parking brake will be automatically released by depressing the accelerator pedal. However, the automatic release function does not operate under the following conditions.
● Any door (other than the trunk lid or rear gate) is open.
● The driver’s seatbelt is not fastened. If the parking brake is automatically released, the brake system warning light and the indicator on the parking brake switch turn off.
NOTE
Even if you have applied the parking brake by pressing the parking brake switch, the parking brake will be automatically released when the accelerator pedal is depressed.
Electronic parking brake
1) Parking brake switch
2) Hill Holder switch
3) Indicator light
WARNING
● Before exiting the vehicle, make sure that you turn off the engine. Otherwise,
the parking brake may be release ...
Hill Holder function
The electronic parking brake system has a Hill Holder function. If the Hill Holder
function is activated, the parking brake will be automatically applied when stopping
on an uphill slope with the ...
See also:
Installing a Child Seat
After selecting a proper child seat
and a good place to install the seat,
there are three main steps in
installing the seat:
1. Properly secure the child seat to
the vehicle. All child seats ...
Garage door opener — if equipped
HomeLink replaces up to three remote controls (handheldtransmitters) that operate
devices such as garagedoor openers, motorized gates, lighting or home securitysystems.
The HomeLink unit operates ...
Turning on the high beam headlights
1 With the headlights on, push
the lever away from you to
turn on the high beams.
Pull the lever toward you to the
center position to turn the high
beams off.
2 Pull the lever toward you a ...
