Subaru Legacy: Airflow mode selection button - Control panel - Automatic climate control system (if equipped) - Climate control - Subaru Legacy Owners ManualSubaru Legacy: Airflow mode selection button

Select the desired airflow mode by pressing the airflow mode selection button.

Select the desired airflow mode by pressing the airflow mode selection button. The selected airflow mode is shown on the display.

There are four airflow modes that activate the following air outlets.

outlets (Ventilation): Instrument panel outlets

and foot outlets (Bi-level): Instrument panel outlets and foot outlets

outlets of the instrument panel and some through windshield defroster outlets (A (Heat): Foot outlets, both side outlets of the instrument panel and some through windshield defroster outlets (A small amount of air flows to the windshield and both side windows to prevent fogging.)

outlets, foot outlets and both side outlets of the instrument panel (Heat-def): Windshield defroster outlets, foot outlets and both side outlets of the instrument panel

NOTE

When the “air conditioner compressor automatically operates to quickly defog the windshield” mode is selected, the air conditioner compressor automatically operates to quickly defog the windshield and the air inlet selection is automatically set to the “outside air” mode.

    A/C – Air conditioner button
    If the windshield starts to fog when the climate control system is operated in the AUTO mode, press the air conditioner button “A/C” to defog and dehumidify. When this button is pressed, the ...

    Air inlet selection button
    Select airflow by pressing the air inlet selection button “”. ON position (recirculation): Interior air is recirculated inside the vehicle. Press the air inlet selection button to the ON posi ...

    See also:

    Problems with PARKTRONIC
    Problem Possible causes/consequences and - Solutions Only the red segments in the PARKTRONIC warning displays are lit. You also hear a warning tone for approximately ...

    Automatic operation (if so equipped)
     Tilt operation Push the switch (1) up or down to adjust the steering wheel to the desired position. Entry/Exit function The automatic drive positioner system will make the steering wheel mo ...

    The concept
    Two radar sensors below the rear bumper monitor the area behind and next to the vehicle at speeds above approx. 30 mph/50 km/h. The system indicates whether there are vehicles in the blind sp ...