Buick Regal: Wiper Blade Replacement - Vehicle Checks - Vehicle Care - Buick Regal Owners ManualBuick Regal: Wiper Blade Replacement

Windshield wiper blades should be inspected for wear or cracking. See Scheduled Maintenance  for more information.

It is a good idea to clean or replace the wiper blade assembly on a regular basis or when worn. For proper windshield wiper blade length and type, see Maintenance Replacement Parts .

Notice: Allowing the wiper blade arm to touch the windshield when no wiper blade is installed could damage the windshield. Any damage that occurs would not be covered by your warranty. Do not allow the wiper blade arm to touch the windshield.

To replace the wiper blade:

1. Pull the wiper assembly away from the windshield.

2. Lift up on the latch in the middle of the wiper blade where the wiper arm attaches.

2. Lift up on the latch in the middle of the wiper blade where the wiper arm attaches.
3. With the latch open, pull the wiper blade down toward the windshield far enough to release it from the J-hooked end of the wiper arm.
4. Remove the wiper blade.
5. Reverse Steps 1 through 3 for wiper blade replacement.

    Park Brake and P (Park) Mechanism Check
    WARNING When you are doing this check, the vehicle could begin to move. You or others could be injured and property could be damaged. Make sure there is room in front of the vehicle in case it b ...

    Headlamp Aiming
    Headlamp aim has been preset at the factory and should need no further adjustment. However, if the vehicle is damaged in a crash, the headlamp aim may be affected. Aim adjustment to the low-beam head ...

    See also:

    Telephone setup
    Requirements for cradleconnection Your phone must be fitted in a mobilephone holder before it can be used as acradle phone with your handsfree/voicecontrol system. You will be able topurchase the cor ...

    Flash Lights With Lock
    The feature will cause the turn signal lights to flash when the doors are locked or unlocked with the RKE transmitter. This feature can be turned on or turned off. To change the current setting, ...

    Fast-forwarding and reversing files
    Press and hold or . ...