Subaru Legacy: Turbo models
1) Air intake duct 2) Air cleaner case 3) Clamp
1. Remove the hydraulic hose in the power steering system from the clip on the air intake duct.
2. Remove the hydraulic hose from the clip on the right side of the air cleaner case.
3. Unsnap the two clamps holding the air cleaner case cover.
4. Open the air cleaner case and remove the air cleaner element.
5. Clean the inside of the air cleaner case and case cover with a damp cloth and install a new air cleaner element.
6. If the air cleaner case has been removed, insert the three projections on the air cleaner case into the slits on the air cleaner case cover.
7. Install the removed parts in the reverse order of removal.
Replacing the air cleaner element
Replace the air cleaner element according to the maintenance schedule in the
“Warranty and Maintenance Booklet”. Under extremely dusty conditions, replace it
more frequently. It is recommended ...
Spark plugs
It may be difficult to replace the spark plugs. It is recommended that you have
the spark plugs replaced by your SUBARU dealer.
The spark plugs should be replaced according to the maintenance sched ...
See also:
High beam indicator light
(blue)
This blue light comes on when the headlight high
beams are on and goes out when the low beams
are selected.
The high beam indicator light also comes on
when the passing signal is activated. ...
Engine low oil level warning light
The engine low oil level warning light illuminates when the ignition switch is
turned to the “ON” position and turns off after approximately 2 seconds.
This light also illuminates when the en ...
Key
Illuminated ignition switch
Whenever a front door is opened, the ignition switch will be illuminated for
your convenience, provided the ignition switch is not in the ON position. The light
will ...
