Subaru Legacy: To temporarily cancel the cruise control
The cruise control can be temporarily canceled in the following ways.
● Press the “CANCEL” button.
● Depress the brake pedal.
● Depress the clutch pedal (MT models only).
● Shift the select lever into the “N” position (AT and CVT models).
● Shift the shift lever into the neutral position (MT models only).
The cruise control set indicator light in the combination meter turns off when the cruise control is canceled.
To resume the cruise control after it has been temporarily canceled and with vehicle speed of approximately 20 mph (32 km/h) or more, press the “RES/SET” switch to the “RES” side to return to the original cruising speed automatically.
The cruise control set indicator light in the combination meter will automatically illuminate at this time.
To set cruise control
1. Press the “CRUISE” main switch button. The cruise control indicator light on the combination meter will illuminate. 2. Depress the accelerator pedal until the vehicle reaches the desired ...To turn off the cruise control
There are two ways to turn off the cruise control: ● Press the “CRUISE” main switch button again. ● Turn the ignition switch to the “Acc” or “LOCK” position (but only when th ...See also:
Function
The driver sees what is behind the vehicle and if a person or animal should suddenly
appear from the side.
PAC is mounted on the rear of the trunk lid, near the opening handle.
The camera has bu ...
Headlight control sensor (if equipped)
The sensor may not function properly if
an object is placed on the sensor, or anything
that blocks the sensor is affixed to
the windshield.
Doing so interferes with the sensor
detecting the ...
Reading Lamps
There are front and rear reading
lamps.
The front reading lamps are located
in the overhead console.
The rear reading lamps are located
in the headliner.
or
: Press to turn each lamp
...