Chrysler 200: Setup - Commands - Voice Command — If Equipped - Understanding the features of your vehicle - Chrysler 200 Owners ManualChrysler 200: Setup

To switch to system setup, you may say on of the following:
• “Change to setup”
• “Switch to system setup”
• “Change to setup”
• “Main menu setup” or
• “Switch to setup”

In this mode, you may say the following commands:
• “Language English”
• “Language French”
• “Language Spanish”
• “Tutorial”
• “Voice Training”

NOTE:
Keep in mind that you have to press the Voice Command wait for the beep before button first and wait for the beep before speaking the “Barge In” commands.

    Memo
    To switch to the voice recorder mode, say “Memo”. In this mode, you may say the following commands: • “New Memo” (to record a new memo) — During the recording, you may press the Voic ...

    Voice Training
    For users experiencing difficulty with the system recognizing their voice commands or numbers the Uconnect™ Voice “Voice Training” feature may be used. 1. Press the Voice Command button, ...

    See also:

    Problems with the seat heating
    The seat heating has switched off prematurely or cannot be switched on. The vehicle's electrical system voltage is too low because too many electrical consumers are switched on. •► Sw ...

    Hood and engine compartment
    Turn the handle located under the left side of the dash approximately 20-25 degrees clockwise to release the hood lock. Lift the hood slightly. Press the release control (located under the r ...

    Rear Cupholders
    The rear seat cupholders are located in the armrest between the rear seats. Pull down the armrest to use the cupholders. Rear Cupholders Rear Seat Bottle Holder There are built-in bottle hold ...