Mazda Mazda6: SeatWarmer
Press the HI or LO side of the seat warmer switch with the ignition is switched ON.
The indicator on the switch illuminates and the seat warms up.
If a higher temperature is preferred, press the HI side of the switch, and for a lower temperature, press the LO side.
When not using the seat warmer, set the switch to neutral with neither HI or LO depressed.
WARNING:
Be careful when using the seat warmer. The heat from the seat warmer may be too hot for some people, as indicated below, and could cause a low-temperature burn.
Infants, small babies, elderly people, and physically challenged people.
People with delicate skin.
People who are excessively fatigued.
People who are drunk.
People who have taken sleepinducing medicine such as sleeping pills or cold medicine.
Do not use the seat warmer with anything having high moistureretention ability such as a blanket or cushion on the seat. The seat may be heated excessively and cause a low-temperature burn.
Do not use the seat warmer even when taking a short nap in the vehicle. The seat may be heated excessively and cause a lowtemperature burn.
Do not place heavy objects with sharp projections on the seat, or insert needles or pins into it. This could cause the seat to become excessively heated and result in injury from a minor burn.
CAUTION:
Do not use organic solvents to clean the seat. It may damage the seat surface and the heater.
NOTE:
Use the seat warmer when the engine is running, and do not continue to use it for a long period of time.
The temperature of the seat warmer cannot be adjusted beyond High and Low because the seat warmer is controlled by a thermostat.
Head Restraints
Head restraints are intended to help protect you and the passengers from neck injury. WARNING: Always drive with the head restraints installed when seats are being used and make sure they are pr ...Seat Belt Precautions
Seat belts help to decrease the possibility of severe injury during accidents and sudden stops. Mazda recommends that the driver and all passengers always wear seat belts. All of the seat belt re ...See also:
Removing covers from rear parcel shelf
Remove the top tether anchor cover or key cylinder
cover as follows:
1. Lift the cover to the full open position.
2. Rotate the cover in the direction shown,
disengaging the hinge at 1 and sli ...
Malfunction
A message is displayed in the instrument cluster.
HDC is not available, e.g., due to elevated
brake temperatures. ...
Notes on selecting, mounting and
replacing tires
- Only mount tires and wheels of the same
type and make.
- Only mount tires of the correct size onto
the wheels.
- After mounting new tires, run them in at
moderate speeds fo ...