Toyota Camry: Replacing light bulbs - Light bulbs - Do-it-yourself maintenance - Maintenance and care - Toyota Camry Owners ManualToyota Camry: Replacing light bulbs

■ Headlight high beam and daytime running light

Turn the bulb base counterclockwise.

Turn the bulb base counterclockwise.

Unplug the connector while

Unplug the connector while depressing the lock release.

■ Headlight low beam (halogen bulb)

Turn the bulb base counterclockwise.

Turn the bulb base counterclockwise.

Unplug the connector while

Unplug the connector while depressing the lock release.

■ Fog light (if equipped)

Turn the steering wheel in the

Turn the steering wheel in the opposite direction of the fog light that you wish to replace.

For example, if you wish to replace the fog light on the left side, turn the steering wheel to the right.

Remove the fender liner clip.

Remove the fender liner clip.

  1. After turning the clip, pull the clip until it stops.
  2. Turn the clip again, and then pull out the clip.

Partly remove the fender liner

Partly remove the fender liner and unplug the connector while depressing the lock release.

Turn the bulb base counterclockwise.

Turn the bulb base counterclockwise.

■ Front turn signal/parking light

Turn the bulb base counterclockwise.

Turn the bulb base counterclockwise.

Remove the light bulb.

Remove the light bulb.

■ Front side marker light

Turn the bulb base counterclockwise.

Turn the bulb base counterclockwise.

Remove the light bulb.

Remove the light bulb.

■ Rear side marker light, rear turn signal light and stop/tail light

Open the trunk lid and remove

Open the trunk lid and remove the luggage trim cover clips.

Pull the hook while depressing

Pull the hook while depressing the button.

Partly remove the luggage trim

Partly remove the luggage trim cover.

Turn the bulb base counterclockwise.

Turn the bulb base counterclockwise.

  1. Rear side marker light
  2. Rear turn signal light
  3. Stop/tail light

Remove the light bulb.

Remove the light bulb.

  1. Rear side marker light
  2. Rear turn signal light
  3. Stop/tail light

■ Back-up light

Open the trunk lid and remove

Open the trunk lid and remove the clips. Then partly remove the trunk panel cover.

Unplug the connector while

Unplug the connector while depressing the lock release.

Turn the bulb base counterclockwise.

Turn the bulb base counterclockwise.

Remove the light bulb.

Remove the light bulb.

■ License plate light

Remove the lens.

Remove the lens.

Insert a properly sized Allen key into the hole of the lens, and pry off the lens as shown in the illustration.

To prevent damaging the vehicle, wrap the tip of the Allen key with a tape.

Remove the light bulb.

Remove the light bulb.

■ Lights other than the above

If any of the lights listed below has burnt out, have it replaced by your Toyota dealer.

● Headlight low beams (discharge bulb)
● High mounted stoplight

    Light bulbs
    You may replace the following bulbs by yourself. The difficulty level of replacement varies depending on the bulb. If necessary bulb replacement seems difficult to perform, contact your Toyota dea ...

    Discharge headlights (if equipped)
    If voltage to the discharge bulbs is insufficient, the bulbs may not come on, or may go out temporarily. The discharge bulbs will come on when normal power is restored. ...

    See also:

    Clock
    The infotainment system controls are used to access the time and date settings through the menu system. See Operation  for information about how to use the menu system. Setting the Time and Date ...

    Emergency Brake Assistance
    EBA is designed to provide full brake effect immediately in the event of sudden, hard braking. The system is activated by the speed with which the brake pedal is depressed. When the EBA system is ...

    Tires
    Use a stiff brush with tire cleaner to clean the tires. Notice: Using petroleum-based tire dressing products on the vehicle may damage the paint finish and/or tires. When applying a tire d ...