Subaru Legacy: Removing air intake duct - Maintenance tips - Maintenance and service - Subaru Legacy Owners ManualSubaru Legacy: Removing air intake duct

Use a screwdriver to undo the clips on the air intake duct, then remove the air

Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct. Refer to “Type A clips” F11-5.

    Removing and reinstalling clips
    Removing clips There are several types of clips used for your vehicle Type A clips 1. Turn the clips counterclockwise using a flat-head screwdriver until the center portion of the clip is raise ...

    Pulling off the fender lining
    It is necessary to pull off the fender lining when replacing some bulbs. 1. Start the engine and turn the steering wheel fully in the opposite direction of the bulb to be replaced. 2. Stop the eng ...

    See also:

    Redial
    • Press the button to begin. • After the “Ready” prompt and the following beep, say “Redial”. • The Uconnect™ Phone will call the last number that was dialed from your mobile ph ...

    Small children
    Children that are over 1 year old and weigh at least 20 lbs (9 kg) should remain in a rear-facing child restraint as long as possible up to the height or weight limit of the child restraint. Forwar ...

    Starting the engine
    WARNING Always wear appropriate shoes when operating your vehicle. Unsuitable shoes (high heels, ski boots,etc.) may interfere with your ability to use the brake, accelerator pedal, and clutch (i ...