Nissan Altima: Programming trouble-diagnosis
If the HomeLink does not quickly learn the handheld transmitter information:
● replace the hand-held transmitter batteries with new batteries.
● position the hand-held transmitter with its battery area facing away from the HomeLink surface.
● press and hold both the HomeLink and hand-held transmitter buttons without interruption.
● position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLink surface. Hold the transmitter in that position for up to 15 seconds. If HomeLink is not programmed within that time, try holding the transmitter in another position – keeping the indicator light in view at all times.
If you continue to have programming difficulties, please contact the NISSAN Consumer Affairs Department. The phone numbers are located in the Foreword of this manual.
Operating the HomeLink universal
transceiver
The HomeLink Universal Transceiver (once programmed)
may now be used to activate the garage
door, etc. To operate, simply press the appropriate
programmed HomeLink Universal
Transceiver button. Th ...
Clearing the programmed information
Individual buttons cannot be cleared. However,
to clear all programming, press and hold the two
outside buttons and release when the indicator
light begins to flash (approximately 20 seconds). ...
See also:
Carbon Monoxide Warnings
WARNING!
Carbon monoxide (CO) in exhaust gases is deadly.
Follow the precautions below to prevent carbon
monoxide poisoning:
• Do not inhale exhaust gases. They contain carbon
monoxide, a col ...
Air conditioner operation
Start the engine, turn the fan control dial to the
desired position, and push in the button to
activate the air conditioner. When the air conditioner
is on, cooling and dehumidifying functions
are ...
Conditions under which the Blind Spot Monitor will not detect a vehicle
The Blind Spot Monitor is not designed to detect the following types of
vehicles
and/or objects:
●Vehicles traveling from the opposite direction
●Small motorcycles, bicycles, pedestr ...
