Chrysler 200: Power Steering Fluid Check - Power Steering - Starting and operating - Chrysler 200 Owners ManualChrysler 200: Power Steering Fluid Check

Checking the power steering fluid level at a defined service interval is not required. The fluid should only be checked if a leak is suspected, abnormal noises are apparent, and/or the system is not functioning as anticipated.

Coordinate inspection efforts through an authorized dealer.

CAUTION!
Do not use chemical flushes in your power steering system as the chemicals can damage your power steering components. Such damage is not covered by the New Vehicle Limited Warranty.

WARNING!
Fluid level should be checked on a level surface and with the engine off to prevent injury from moving parts and to ensure accurate fluid level reading. Do not overfill. Use only manufacturer’s recommended power steering fluid.

If necessary, add fluid to restore to the proper indicated level. With a clean cloth, wipe any spilled fluid from all surfaces. Refer to “Fluids, Lubricants, and Genuine Parts” in “Maintaining Your Vehicle” for further information.

    Power Steering
    The standard power steering system will give you good vehicle response and increased ease of maneuverability in tight spaces. The system will provide mechanical steering capability if power assi ...

    Parking Brake
    Before leaving the vehicle, make sure that the parking brake is fully applied. Also, be certain to leave the transmission in PARK. The parking brake lever is located in the center console. To ap ...

    See also:

    Autolight system (if so equipped)
    The autolight system allows the headlights to be set so they turn on and off automatically. The autolight system can: ● Turn on the headlights, front parking, tail, license plate and instr ...

    Audio Source
    VOL/ (Volume/Power): 1. Press to turn the radio on or off. 2. Turn to increase or decrease the volume of the active source (i.e., current audio source, active navigation voice guidance, or ...

    FM/AM radio operation
    FM/AM band select: Pressing the RADIO button will change the band as follows: AM ←→ FM When the RADIO button is pressed while the ignition switch is in the ACC or ON position, the ra ...