Mercedes-Benz E-Class: Opening/closing the garage door
Once programmed, the integrated garage door opener will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.
•► Turn the SmartKey to position 2 in the ignition lock.
•► Press transmitter button 2, 3 or 4 in the overhead control panel that you have programmed to operate the garage door.
Garage door system with a fixed code:
indicator lamp 1 lights up green.
Garage door system with a rolling code:
indicator lamp 1 flashes green.
The transmitter will transmit a signal for as long as the transmitter button is being pressed. After a maximum of ten seconds, transmission is terminated and indicator lamp 1 flashes yellow. Press the transmitter button again, if necessary.
Programming the integrated garage
door opener on the rear-view mirror
Programming
WARNING
Only press the transmitter button on the
integrated garage door opener if there are no
persons or objects present within the sweep
of the garage door. People could othe ...
Clearing the memory of the integrated
garage door opener on the rear-view
mirror
•► Turn the SmartKey to position 2 in the
ignition lock.
•► Press transmitter buttons 2 and 4.
The indicator lamp lights up yellow.
•► Press and hold transmitter buttons 2 ...
See also:
Introduction
Display when the radio is receiving an HD Radio broadcast
NOTE
HD radio volume may fade in and out at times due to coverage limitations.
HD radio is a brand name registered by the Ibiquity d ...
Three-Way Calling
Three-way calling must be
supported on the cell phone and
enabled by the wireless service
carrier.
1. While on a call, press .
2. Say “Three-way call.”.
3. Use the dial or call command to ...
California Fuel Requirements
If the vehicle is certified to meet California Emissions Standards, it is designed to operate on fuels that meet California specifications.
See the underhood emission control label. If this fuel is n ...
