Chrysler 200: Oil Change Required — If Equipped - Electronic Vehicle Information Center (EVIC) — If Equipped - Understanding your instrument panel - Chrysler 200 Owners ManualChrysler 200: Oil Change Required — If Equipped

Your vehicle is equipped with an engine oil change indicator system. The Oil Change Required message will flash in the EVIC display for approximately five seconds after a single chime has sounded to indicate the next scheduled oil change interval. The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style.

Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN position. To turn off the message temporarily, press and release the MENU button. To reset the oil change indicator system (after performing the scheduled maintenance), perform the following procedure:

1. Turn the ignition switch to the ON position (Do not start the engine.) 2. Fully depress the accelerator pedal slowly three times within 10 seconds.

3. Turn the ignition switch to the LOCK position.

NOTE:
If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary repeat this procedure.

    Electronic Vehicle Information Center (EVIC) Displays
    When the appropriate conditions exist, the EVIC displays the following messages: • Turn Signal On (with a continuous warning chime after one mile traveled) • Left Front Turn Signal Lamp Out ...

    EVIC Main Menu
    To step to each main menu feature press and release the MENU button once for each step. A step from the last item in the list will cause the first item in the feature list to be displayed. The f ...

    See also:

    Reformulated gasoline
    Some fuel suppliers are now producing reformulated gasolines. These gasolines are specially designed to reduce vehicle emissions. NISSAN supports efforts towards cleaner air and suggests that you ...

    Brake/clutch fluid
    Check brake fluid level in the brake fluid reservoir. The level should be between “MIN” and “MAX” marks on the side of the reservoir. Use only hydraulic brake fluid conforming to DOT 3 or ...

    Filter replacement
    1. Open the glove box and remove the support strap (1). 2. With the glove box open, remove the stoppers by turning them counterclockwise on both sides. 3. Remove the climate control air filter ...