Nissan Altima: Manual control - Bluetooth Hands-Free Phone System without
Navigation System (if so equipped) - Monitor, climate, audio, phone and voice recognition systems - Nissan Altima Owners ManualNissan Altima: Manual control

While using the voice recognition system, it is possible to select menu options by using the steering wheel controls instead of speaking voice commands. The manual control mode does not allow dialing a phone number by digits. The user may select an entry from the Phonebook or Recent Calls lists. To re-activate voice recognition, exit the manual control mode by pressing and holding the PHONE/END (that ) button. At that time, pressing the PHONE/SEND (button) button will start the Hands Free Phone System.

Operating tips

● To enter manual control mode, start the voice recognition system and tilt the tuning (will) switch up or down. The system will speak Showing Manual Options when manual controls are initially activated.

● To browse the menu options, tilt the tuning (will) switch up or down. The system will always speak the current menu option. Depending on the audio display, it will also show the current menu option.

● To select the current menu option, press the PHONE/SEND (● To go back to the previous menu, press the ) button.

● To go back to the previous menu, press the PHONE/END (menu is the Main Menu, pressing the) button. If the current menu is the Main Menu, pressing the PHONE/END (Phone system.) button will exit the Phone system.

● To exit the manual control mode, press and hold the PHONE/END (seconds.) button for 5 seconds.

    Training phrases
    During the SA mode, the system instructs the trainer to say the following phrases. (The system will prompt you for each phrase.) ● phonebook transfer entry ● dial three oh four two nin ...

    Troubleshooting guide
    The system should respond correctly to all voice commands without difficulty. If problems are encountered, try the following solutions. Where the solutions are listed by number, try each solution ...

    See also:

    Fault tracing and actions
    If the message Windscreen Sensors blocked is displayed, this means that the camera is obscured and cannot detect pedestrians, vehicles or road marker lines in front of the vehicle. This, in turn, ...

    The concept
    The vehicle can be accessed without activating the remote control. All you need to do is to have the remote control with you, e.g., in your jacket pocket. The vehicle automatically detects the r ...

    Cold weather precautions
    If you wish to check your vehicle before the approach of cold weather, the following advice is worth noting: Make sure that the engine coolant contains 50 percent antifreeze. Any other mixtur ...