Volvo S60: License plate lighting - Introduction - Maintenance and specifications - Volvo S60 Owners ManualVolvo S60: License plate lighting

1. Remove the screws with a screwdriver.

1. Remove the screws with a screwdriver.

2. Carefully detach the entire bulb housing and pull it out.

3. Replace the bulb.

4. Reinsert the entire bulb housing and tighten the screws.

    Location of taillight bulbs
    Brake lights (LEDs) Brake light Backup light Turn signals Rear fog light (driver’s side only) NOTE If an error message remains in the display after a faulty bulb has been repla ...

    Trunk lighting
    NOTE Before starting to replace a bulb, see page 306. The trunk lighting is located on opposite sides of the trunk. 1. Insert a screwdriver and gently turn so that the bulb housing comes loo ...

    See also:

    Automatic Hold
    The concept This system assists the driver by automatically setting and releasing the brake, such as when moving in stop-and-go traffic. The vehicle is automatically held in place when it is s ...

    For 520i and 528i: Check oil level
    The concept The oil level is monitored electronically during driving and shown on the Control Display. If the oil level reaches the minimum level, a check control message is displayed. Displayi ...

    Rear Seat Pass-Through Door
    The vehicle may have a door in the rear seat that provides access to the trunk. Lower the rear seat armrest to access the pass-through door. Pull the release handle to open the door. To close, pus ...