Subaru Legacy: Legacy - License plate light - Replacing bulbs - Maintenance and service - Subaru Legacy Owners ManualSubaru Legacy: Legacy

NOTE

It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary.

1. Open the trunk.

2. Remove the trunk trim lining by removing the 12 clips and the trunk trim handle.

2. Remove the trunk trim lining by removing the 12 clips and the trunk trim handle.

3. Turn the bulb socket counterclockwise and remove it.

3. Turn the bulb socket counterclockwise and remove it.

4. Pull the bulb out of the bulb socket and replace it with a new one.

5. Install the bulb socket by turning it clockwise.

6. Reinstall the trunk trim lining.

    Outback
    1. Remove the mounting screws using a Phillips screwdriver. 2. Remove the lens. 3. Pull the bulb out of the socket. 4. Install a new bulb. 5. Reinstall the lens. 6. Tighten the mounting screw ...

    See also:

    What Makes an Airbag Inflate?
    In a deployment event, the sensing system sends an electrical signal triggering a release of gas from the inflator. Gas from the inflator fills the airbag causing the bag to break out of the ...

    FM selection
    Press the “FM” button when the radio is on to select FM1, FM2 or FM3 reception. Each brief press of the “FM” button changes the radio in the following sequence starting from the last FM r ...

    Heated seats
    Driver side Passenger side CAUTION: Operating the heated seats with theengine off will drain the battery. The heated seats will operate when theignition switch is in position II. ...