Toyota Camry: Key reminder function - Engine (ignition) switch (vehicles without a smart key system) - Driving procedures - When driving - Toyota Camry Owners ManualToyota Camry: Key reminder function

A buzzer sounds if the driver’s door is opened while the engine switch is in the “LOCK” or “ACC” position to remind you to remove the key.

CAUTION
■When starting the engine
Always start the engine while sitting in the driver’s seat. Do not depress the accelerator pedal while starting the engine under any circumstances.
Doing so may cause an accident resulting in death or serious injury.
■Caution when driving
Do not turn the engine switch to the “LOCK” position while driving. If, in an emergency, you must turn the engine off while the vehicle is moving, turn the engine switch only to the “ACC” position to stop the engine. An accident may result if the engine is stopped while driving.

NOTICE
■To prevent battery discharge
Do not leave the engine switch in the “ACC” or “ON” position for long periods of time without the engine running.
■When starting the engine
●Do not crank the engine for more than 30 seconds at a time. This may overheat the starter and wiring system.
●Do not race a cold engine.
●If the engine becomes difficult to start or stalls frequently, have the engine checked immediately.

    When the steering lock cannot be released
    When starting the engine, the engine switch may seem stuck in the “LOCK” position. To free it, turn the key while turning the steering wheel slightly left and right. ...

    Engine (ignition) switch (vehicles with a smart key system)
    Performing the following operations when carrying the electronic key on your person starts the engine or changes “ENGINE START STOP” switch modes. ...

    See also:

    Fuel requirements
    Your new vehicle is designed to use only unleaded fuel having a pump octane number ((R+M)/2) of 87 (Research Octane Number 91) or higher. Your new vehicle is designed to obtain maximum performance ...

    Jump starting
    Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm to yourself or damage to your vehicle or battery, follow the jump starting procedures. If in doubt, we strongly recomme ...

    Replacing a Front Side Marker Light Bulb
    1. To change the bulb on the driver’s side, start the engine, turn the steering wheel all the way to the right, then turn off the engine. To change the bulb on the passenger’s side, tu ...