Nissan Maxima: Installing top tether strap
INSTALLING TOP
TETHER STRAP
First, secure the child restraint with the Latch lower anchors (rear outboard seat positions only) or the seat belt, as applicable.
1. Flip up the anchor covers from the anchor point which is located directly behind the child seat.
2. Position the top tether strap over the top of the seatback.
3. Secure the tether strap to the tether anchor point on the rear parcel shelf.
4. Tighten the tether strap according to the manufacturers instructions to remove any slack.
If you have any questions when installing a top tether strap, consult your NISSAN dealer for details.
Forward-facing child restraint installation using the seat belts
WARNING: The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being ...Booster seats
Precautions on booster seats WARNING: If a booster seat and seat belt are not used properly, the risk of a child being injured in a sudden stop or collision greatly increases: Make sure the shoul ...See also:
Power outlet
Front center console
The power outlets are for powering electrical accessories such as cellular telephones.
They are rated at 12 Volt, 120 W (10A) maximum.
The power outlet in the front co ...
Closing the trunk
To close the trunk, lower the trunk lid, then press down on it until it locks.
To be sure the trunk lid is securely fastened, always check by trying to pull it
up again.
WARNING
The trunk lid sh ...
Useful information
This Operator's Manual describes all
models and all standard and optional
equipment of your vehicle available at the
time of publication of the Operator's
Manual. Country-specific differences ...